3D Scan compared to Leica RTC360

[Ascent]

Hey hey all, So wanted to open up some discussion about the real accuracy of 3D Scan software.
What I have found is that we scanned a small lot with a storage shed on it to get some measurements with the Skydio 2+ enterprise and scanned the shed with a Leica RTC360 terrestrial laser scanner.
We use the RTC a lot and I knew the Skydio was not going to be as accurate but wanted to see how close it could get. I mean reading what the company states it is or could be survey grade in the cm range.
Well the shed is 31' x 14.5' and in that short distance there is an 7.7" east, 7.2" north and 6.3" west discrepancy in wall positions.
Now grant it we did not use GSPs (Which we will try next) we wanted to see what it did on its own. I am hoping that the putting it on control will fix this but wanted to see what everyone else was experiencing and just start up a discussion on best practice's.

I processed on both WebODM and Pix4d Mapper and both are virtually exact. The average GSD is 0.36cm/0.14" per Pix4D... That's 3.6mm So at an average of 3x's that is 10.8mm so basically 1cm supposed accuracy if I am doing my math right haaa haa

We use a lot of terrestrial, mobile and drones (other than the Skydio) to do our everyday scanning and know the tricks of the trade to get accuracy with their data but wanted to implement the Skydio of tight places and interiors. If it isn't more accurate than that it is basically only good for observation pic's. Far from what I was sold on.

So anyone out there up to a conversation to explore?

I just want to see if anyone has figured a way to get this tighter or has any ideas on processing

 

[LyleCDG]

Wow.. crickets for over a year. lol. I've been doing photogrammetry with drones for many years. It is unlikely to ever get accurate measurements without some survey points (GSDs). A rule of thumb is to use 5 GSDs for every battery used during flight. I try to use a minimum of 5 targets regardless of size of area. Typically I use more than five. We get very good, (1/10th foot accuracy) when using GSDs. We frequently do laser scanning AND a drone flight for some jobs. I can use data from the laser scan as 'targets' when processing the drone flight in Pix4D or Autodesk ReCap Photo with equally good results. But, no, I never use a point cloud for design unless we've processed it with GSD targets.

 

[Airwolf]

Using 3D Scan Map capture on the Skydio X10 and I am not getting a proper model when the scan is completed, and the images are processed? Any ideas? I am scanning a post wildfire area with a 60% slope on average. Area is about 20 acres.

Since I can't upload a tiff imager here I have attached a screen shot of the tiff imager the Skydio generates in the controller.